Beta-propeller phytase

BPP (PDBID: 3AMR). Catalytically important calcium ions 4-8 are in green and possibly less important calcium ions 1-3 and 9-11 are in magenta. N- and C-terminals, propeller "blades" and active site bound myo-inositol hexasulfate (IHS, a phytate analogue) are shown in the picture.

β-propeller phytases (BPPs) are a group of enzymes (i.e. protein superfamily) with a round beta-propeller structure. BPPs are phytases, which means that they are able to remove (hydrolyze) phosphate groups from phytic acid and its phytate salts. Hydrolysis happens stepwise and usually ends in myo-inositol triphosphate product which has three phosphate groups still bound to it. The actual substrate of BPPs is calcium phytate and in order to hydrolyze it, BPPs must have Ca²⁺ ions bound to themselves. BPPs are the most widely found phytase superfamily in the environment and they are thought to have a major role in phytate-phosphorus cycling in soil and water. As their alternative name alkaline phytase suggests, BPPs work best in basic (or neutral) environment. Their pH optima is 6–9, which is unique among the phytases.

Potential uses

As of April 2018, BPPs are not used commercially, but they may have potential for such use. Histidine acid phytases (HAPs) are the only group of phytases which are used in animal feed at the moment.

Animal feed

Recombinant phytases are added commonly in agriculture to animal feed of monogastric animals to enhance the feed's nutrient bioavailability. These nutrients include phosphorus which is bound to phytates in the form of their phosphate groups. In contrast to ruminants like cattle, gut bacteria of monogastric animals like pigs and chickens can't properly hydrolyze these groups free so that the digestive system of the animal can use the phosphorus. Unabsorbed phosphorus is thus wasted and may end up into the environment in animal manure via agricultural runoff and cause eutrophication. Phytic acid can also work as an antinutrient: it can chelate calcium from feed and decrease its bioavailability up to 60–70% of the feed's total calcium content. Phytase addition improves calcium availability and can also improve the bioavailability of iron and zinc. It might also increase the availability of copper and manganese. Amino acid bioavailability is not enhanced significantly.

In comparison to histidine acid phytases (HAPs), which are often unstable in temperatures higher than 65 °C, BPPs can naturally withstand high temperatures of 80–85 °C. Such temperatures are commonly used in pelleting of animal feed during its manufacture. Unlike HAPs, BPPs have a neutral or alkaline pH optima, which makes it possible to use them in neutral or alkaline environments. This expands potential applications for phytases. BPPs could be used in aquatic animal feed because many of these animals like fishes and shrimps have a neutral or alkaline gastrointestinal tract. BPPs are also phytate specific unlike HAPs, which hydrolyze also other phosphate containing molecules like ADP, GTP and NADH. However, BPPs are catalytically more than 2–60 times slower than current the HAPs. HAPs have a specific catalytic activity of 100–3000 U mg⁻¹. BPPs usually have a specific catalytic activity of less than 50 U mg⁻¹. Because of such low activity practical use of BPPs requires much more research.

Structure

As of April 2018, 7 BPP crystal structures were known: 3AMR, 3AMS, 1H6L, 1POO, 2POO, 1CVM and 1QLG.

Masses of known BPPs are approximately 35–68 kDa. Their donut-shaped β-propeller structure consists of 6 antiparallel beta sheet structures or "blades". One of these blades has 5 β-sheets (blade number 5 in the picture in the beginning of this article) and the rest have 4 β-sheets. There are hydrophobic interactions between these blades which are thought to keep the propeller structure together. These blades form a tunnel-like hole through the enzyme. This tunnel binds some water molecules. In front of the tunnel is the enzyme's active site which is positively charged in total due to Ca²⁺ ions it binds and certain positive amino acid residues. This site binds negatively charged calcium phytate and hydrolyzes phosphates from it.

Motifs

BPP motifs found by Huang et al. shown in a BPP (PDBID: 1H6L). Actual highlighted motifs are DAADDPAIW (red) and NNVDIRY (green).

A 2008 study by Huang et al. compared 66 BPP peptide sequences and found that sequence motifs DA[A/T/E]DDPA[I/L/V]W and NN[V/I]D[I/L/V]R[Y/D/Q] were conserved in all of the studied BPPs. R[Y/D/Q] for example signifies that R and Y, D or Q were found in the sequence, i.e. RY or RD or RQ. 2014 study by Kumar et al. compared 44 BPPs and found 10 motifs. Two of these, DDPAIW[VI][HN]PK[DN]P[ESA]KS and NN[F/V]D[I/V/L], were found in all of the studied BPPs. These were noted to be similar to the ones found in the 2008 study by Huang et al.

Calcium dependence and inhibitors

BPPs are calcium dependent metalloproteins. Their active site has a number of calcium cations (Ca²⁺) bound to it via negatively charged amino acid carboxylate groups. Positive calcium ions are needed to make binding of the negative phytate electrically favorable. Binding happens via phytate's negatively charged phosphate groups along with certain positive amino acid residues of the BPP which bind directly to the phytate. Ca²⁺ concentrations also have an effect on BPP pH optima and thermostability: e.g. with Bacillus sp. KHU-10 BPP the activity is highest with 10 mM of added CaCl₂ at 60 °C and pH 6–9.5. Without added CaCl₂ the pH highest activity is at 40 °C and pH 6.5–8.5.

Removal of Ca²⁺ leads to the loss of catalytic activity which is why Ca²⁺ chelating EDTA inhibits BPPs. Certain point mutations of the calcium binding amino acids also stops enzyme function. Divalent ions like Cd²⁺, Mn²⁺, Cu²⁺, Ba²⁺, Hg²⁺, Zn²⁺, Co²⁺ and Fe²⁺ inhibit BPPs by replacing Ca²⁺ within the enzyme. This is probably due to the fact that these cations are too small in comparison to Ca²⁺ ions, which have a Van der Waals radius (WDV) of 0.99 Å. Co²⁺ has VDW of 0.74 Å for example and is thus probably too small to carry out the same tasks that Ca²⁺ can. However, Sr²⁺ ions can replace Ca²⁺ at least in certain cases without total loss of catalytic function. Sr²⁺ VDW radius is 1.12 Å, and is similar to that of Ca²⁺. Similar compatibility between different ions can be seen in some other enzymes, too.

High Ca²⁺ concentration can enhance BPP catalysis rate up to a limit. When Ca²⁺ concentration surpasses this limit, extra Ca²⁺ ions begin to work as competitive inhibitors. High concentrations of free phytate which not bound to Ca²⁺ also inhibits BPPs. This happens possibly via free phytate mediated chelation of the Ca²⁺ bound to BPPs.

Other types of inhibitors include oxyanionic (oxygen binding) molybdate, tungstate and vanadate. It has been suggested that inhibition with these oxyanions happens because they form trigonal bipyramidal complexes within the active site of the enzyme which are similar to the transition state of the phytate's phosphate group during its hydrolysis. Orthophosphate which is released from phytic acid works as a competitive inhibitor of BPPs. Phytic acid analogue myo-inositol-hexasulphate (IHS) inhibits BPPs and this has been used as an aid in BPP structural studies due to its similarity with phytic acid (see 3AMR).

Hydrolysis mechanism

In a hydrolysis mechanism suggested in 2001 by Shin et al. the Ca²⁺ ions bound to the BPP are divided to hydrolysis and affinity site ions. In the hydrolysis site, Ca²⁺ help the phosphate about to be removed bind to the active site. They also activate a water molecule that participates in the hydrolysis by turning it in to an OH⁻ ion and stabilize the transition state during catalysis. Affinity area ions increase phytate affinity to the active site and keep the phytate still during hydrolysis from its other phosphate groups. Hydrolysis is repeated stepwise until a myo-inositol product with three phosphates is obtained. Other studies support product with three phosphates, but more phosphates can be removed under extreme conditions such as high BPP concentration and lengthened incubation time.

BPP hydrolysis mechanism. It has been suggested that oxyanions like molybdate form complexes similar to the transition state of phosphate hydrolysis (only intermediate state is shown in the picture).

Actual hydrolysis suggested by Shin et al. happens in two steps. Second one is slower and limits the total reaction speed. In the first step carbonyl group withdraws electrons from phosphorus of the phosphate making it electron poor, i.e. leaving it with a positive charge. Simultaneously OH⁻ donates an electron pair to the nominally positive phosphorus in phosphate. A trigonal bipyramidal intermediate state is formed. In the second step phosphoester bond is cleaved when an acidic amino acid residue (BH⁺) donates a proton to the oxygen in the bond. Phosphate group is thus cleaved off.

Hydrolysis routes

Multiple suggested hydrolysis routes exists, but it is uncertain which one is correct or if multiple routes exist. These hydrolysis routes are summarized below.

Suggested BPP hydrolysis routes. Extreme conditions mean high BPP concentration relative to phytic acid concentration and/or lengthened incubation time. Routes begin with phytic acid (Ins(1,2,3,4,6)P₆) or its salt, calcium phytate. E.g. Ins(1,3,5)P₃ has phosphate groups bound to carbons 1, 3 and 5.

See also

• Enviropig
• 3-phytase
• 4-phytase
• 5-phytase
• Xylanase