Config your EBYTE E32 LoRa module with a raspberry pi and a cool GUI
Connections:
M0 --> 3.3v
M1 --> 3.3v
Rx --> gpio14(Txd)
Tx --> gpio15(Rxd)
AUX --> disconnected
Vcc --> 3.3
Gnd --> Gnd
Remember to set up the serial port so it is not being used by the system:
The primary uart https://www.raspberrypi.org/documentation/configuration/uart.md

Execute main.py to execute the program, SerialBin.py is a helper script for sending raw commands to the serial device, to change the serial device modify the variable serial_port