STM32 HAL driver for the MAX30102 pulse oximeter and heart rate sensor.

• In STM32CubeMX, set I2C1 to "I2C" and USART1 to "asynchronous"
• Set up an external interrupt pin in GPIO settings, use "external interrupt mode with falling edge trigger detection" and "pull-up" settings.
• Activate the external interrupt in NVIC settings by checking the corresponding box.
• Connect the INT# pin of your MAX30102 to this external interrupt pin.
• Save and generate code.

• Include max30102_for_stm32_hal.h":

#include "max30102_for_stm32_hal.h"

• If necessary, override the built-in plot function __weak void max30102_plot(uint32_t ir_sample, uint32_t red_sample) in the main file outside the main function:

void max30102_plot(uint32_t ir_sample, uint32_t red_sample) {
  / * Insert your printing logic here * /
}

• Declare an max30102_t object:

max30102_t max30102;

• Initiate the max30102_t object and pass the corresponding I2C handle:

max30102_init(&max30102, &hi2c1);

• Reset the sensor and clear FIFO pointers:

max30102_reset(&max30102);
max30102_clear_fifo(&max30102);

• Set up sensor configurations:

// FIFO configurations
max30102_set_fifo_config(&max30102, max30102_smp_ave_8, 1, 7);
// LED configurations
max30102_set_led_pulse_width(&max30102, max30102_spo2_16_bit);
max30102_set_adc_resolution(&max30102, max30102_spo2_adc_2048);
max30102_set_sampling_rate(&max30102, max30102_spo2_800);
max30102_set_led_current_1(&max30102, 6.2);
max30102_set_led_current_2(&max30102, 6.2);

• Enter measurement mode:

// Enter SpO2 mode
max30102_set_mode(&max30102, max30102_spo2);

• Enable the required interrupts:

// Enable FIFO_A_FULL interrupt
max30102_set_a_full(&max30102, 1);
// Enable die temperature measurement
max30102_set_die_temp_en(&max30102, 1);
// Enable DIE_TEMP_RDY interrupt
max30102_set_die_temp_rdy(&max30102, 1);

• Run interrupt handler once interrupt flag is active:

while (1) {
  // If interrupt flag is active
  if (max30102_has_interrupt(&max30102))
    // Run interrupt handler to read FIFO
    max30102_interrupt_handler(&max30102);
}

• Include max30102_for_stm32_hal.h":

#include "max30102_for_stm32_hal.h"

• Declare the max30102_t object as extern:

extern max30102_t max30102;

• In the corresponding external interrupt handler function, call:

max30102_on_interrupt(&max30102);

• Complie and flash program to microcontroller.
• Read the results from a serial monitor/plotter.
• Refer to ./examples (main.c, stm32f1xx_it.c) and datasheets for further information.